Semax / Selank Blend: dosing, reconstitution and evidence
Two Russian-developed peptides in one vial. Semax is stimulating and pro-focus; Selank is anxiolytic and calming. Together they are used for focus without the wired feeling Semax alone can produce.
Also known as Selank Semax, Semax+Selank, nootropic blend
Semax / Selank Blend quick start
- Route
- SubQ, or intranasal
- Typical dose
- 600–1,200 mcg total blend per dose — usually an even split, but confirm on your label
- Frequency
- Once or twice daily
- Half-life
- Both are short-acting — minutes to a few hours — which is why dosing is daily and effects are felt acutely.
- Cycle
- 2–4 weeks on, then a break. Tolerance to the focus effect builds.
- Vial sizes sold
- 20mg or 30mg
How to run it
- How often
- Once or twice daily
- Cycle length
- 2–4 weeks on, then a break. Tolerance to the focus effect builds.
- Half-life
- Both are short-acting — minutes to a few hours — which is why dosing is daily and effects are felt acutely.
- Route
- SubQ, or intranasal
What people actually run
Paired because they pull in different directions — Semax for drive and focus, Selank for taking the edge off it. The combination is more popular than either alone.
What to expect
Most people tolerate Semax / Selank Blend well. Here is what is worth knowing going in, so nothing catches you by surprise.
Reconstitution guide
Semax / Selank Blend ships as a lyophilised powder and gets mixed with bacteriostatic water before use. How much water you add sets the concentration, which sets how many syringe units make up each dose. One unit on a U-100 syringe is 0.01 mL — the tables below do the arithmetic for the vial sizes you are most likely to be holding.
20mg vial most common
| Water added | Concentration | 600mcg | 1200mcg |
|---|---|---|---|
| 2mL (common) | 10 mg/mL | 0.06 mL 6 units | 0.12 mL 12 units |
| 3mL | 6.67 mg/mL | 0.09 mL 9 units | 0.18 mL 18 units |
30mg vial
| Water added | Concentration | 600mcg | 1200mcg |
|---|---|---|---|
| 2mL (common) | 15 mg/mL | 0.04 mL 4 units | 0.08 mL 8 units |
| 3mL | 10 mg/mL | 0.06 mL 6 units | 0.12 mL 12 units |
Standard steps
- Inspect the vialConfirm the label and that the powder cake is intact. Do not use a cracked or compromised vial.
- Let it reach room temperatureSitting out for a few minutes reduces condensation inside the vial when the seal is broken.
- Disinfect both stoppersWipe the compound vial and the bacteriostatic water vial with a fresh alcohol swab and let them air-dry.
- Draw the bacteriostatic waterUse a sterile syringe to draw the volume you have chosen from the reconstitution table.
- Add the water down the vial wallInject slowly so it runs down the inside wall rather than spraying directly onto the powder. This limits foaming.
- Dissolve gentlySwirl or roll the vial between your hands until the cake dissolves. Never shake — agitation damages peptide bonds. The solution should end up clear.
- Label and refrigerateWrite the reconstitution date and concentration on the vial. Store at 2–8°C. Do not freeze.
This page is an educational research reference and is not medical advice. Semax / Selank Blend is not approved for human use in any jurisdiction. Dose figures reflect the published record and what the community has converged on — starting points to weigh, not instructions. Consult a qualified healthcare provider before starting any protocol.