PEG-MGF: dosing, reconstitution and evidence
A pegylated splice variant of IGF-1 produced by mechanically loaded muscle. Pegylation extends what would otherwise be a few-minute half-life into days.
Also known as Pegylated Mechano Growth Factor, IGF-1Ec
PEG-MGF quick start
- Route
- SubQ
- Typical dose
- 200–400 mcg
- Frequency
- 1–2× weekly
- Half-life
- Extended to several days by pegylation; unmodified MGF lasts only minutes.
- Cycle
- 4–6 weeks.
- Vial sizes sold
- 5mg or 2mg
How to run it
- How often
- 1–2× weekly
- Cycle length
- 4–6 weeks.
- Half-life
- Extended to several days by pegylation; unmodified MGF lasts only minutes.
- Route
- SubQ
What to expect
Most people tolerate PEG-MGF well. Here is what is worth knowing going in, so nothing catches you by surprise.
Known interactions
Interactions involving PEG-MGF's drug class that DoseIQ screens for. Each one cites where it comes from — an FDA label section or the published record — because an interaction warning you can't trace is just noise.
IGF-1 drives glucose into muscle on top of medication doing the same — this is the combination that puts people on the floor.
What to do: This pairing needs your prescriber's explicit awareness, glucose on hand, and monitoring.
Source: Community consensus + IGF-1 pharmacology; the Guru's straight-talk list
Reconstitution guide
PEG-MGF ships as a lyophilised powder and gets mixed with bacteriostatic water before use. How much water you add sets the concentration, which sets how many syringe units make up each dose. One unit on a U-100 syringe is 0.01 mL — the tables below do the arithmetic for the vial sizes you are most likely to be holding.
5mg vial most common
| Water added | Concentration | 200mcg | 400mcg |
|---|---|---|---|
| 2mL (common) | 2.5 mg/mL | 0.08 mL 8 units | 0.16 mL 16 units |
| 3mL | 1.67 mg/mL | 0.12 mL 12 units | 0.24 mL 24 units |
2mg vial
| Water added | Concentration | 200mcg | 400mcg |
|---|---|---|---|
| 2mL (common) | 1 mg/mL | 0.20 mL 20 units | 0.40 mL 40 units |
| 3mL | 666.67 mcg/mL | 0.30 mL 30 units | 0.60 mL 60 units |
Standard steps
- Inspect the vialConfirm the label and that the powder cake is intact. Do not use a cracked or compromised vial.
- Let it reach room temperatureSitting out for a few minutes reduces condensation inside the vial when the seal is broken.
- Disinfect both stoppersWipe the compound vial and the bacteriostatic water vial with a fresh alcohol swab and let them air-dry.
- Draw the bacteriostatic waterUse a sterile syringe to draw the volume you have chosen from the reconstitution table.
- Add the water down the vial wallInject slowly so it runs down the inside wall rather than spraying directly onto the powder. This limits foaming.
- Dissolve gentlySwirl or roll the vial between your hands until the cake dissolves. Never shake — agitation damages peptide bonds. The solution should end up clear.
- Label and refrigerateWrite the reconstitution date and concentration on the vial. Store at 2–8°C. Do not freeze.
This page is an educational research reference and is not medical advice. PEG-MGF is not approved for human use in any jurisdiction. Dose figures reflect the published record and what the community has converged on — starting points to weigh, not instructions. Consult a qualified healthcare provider before starting any protocol.