CJC-1295 with DAC: dosing, reconstitution and evidence
A GHRH analog with a Drug Affinity Complex that binds albumin, extending its life from minutes to days. Produces a sustained elevation in GH and IGF-1 rather than pulses.
Also known as DAC:GRF, CJC-1295 DAC
CJC-1295 with DAC quick start
- Route
- SubQ
- Typical dose
- 1–2 mg
- Frequency
- Once or twice weekly
- Half-life
- Approximately 6–8 days — the longest of the GH secretagogues.
- Cycle
- 12 weeks on, 4 off is common.
- Vial sizes sold
- 5mg or 2mg
How to run it
- How often
- Once or twice weekly
- Cycle length
- 12 weeks on, 4 off is common.
- Half-life
- Approximately 6–8 days — the longest of the GH secretagogues.
- Route
- SubQ
What people actually run
Used where convenience matters more than pulsatility. Less popular than the no-DAC version but well established.
What to expect
Most people tolerate CJC-1295 with DAC well. Here is what is worth knowing going in, so nothing catches you by surprise.
Known interactions
Interactions involving CJC-1295 with DAC's drug class that DoseIQ screens for. Each one cites where it comes from — an FDA label section or the published record — because an interaction warning you can't trace is just noise.
Growth hormone raises glucose and insulin resistance — it works directly against glucose-lowering medication.
What to do: Fasting glucose and HbA1c are worth tracking; medication doses sometimes need adjusting. Your prescriber should know GH peptides are in the picture.
Source: GH pharmacology; tesamorelin label §7
Reconstitution guide
CJC-1295 with DAC ships as a lyophilised powder and gets mixed with bacteriostatic water before use. How much water you add sets the concentration, which sets how many syringe units make up each dose. One unit on a U-100 syringe is 0.01 mL — the tables below do the arithmetic for the vial sizes you are most likely to be holding.
5mg vial most common
| Water added | Concentration | 1mg | 2mg |
|---|---|---|---|
| 2mL (common) | 2.5 mg/mL | 0.40 mL 40 units | 0.80 mL 80 units |
| 3mL | 1.67 mg/mL | 0.60 mL 60 units | 1.20 mL 120 units * |
2mg vial
| Water added | Concentration | 1mg | 2mg |
|---|---|---|---|
| 2mL (common) | 1 mg/mL | 1.00 mL 100 units | 2.00 mL 200 units * |
| 3mL | 666.67 mcg/mL | 1.50 mL 150 units * | 3.00 mL 300 units * |
* More than 100 units — that is more than a single U-100 insulin syringe holds. Either use a larger syringe, split it across two draws, or mix with less water to concentrate it. Adding less water is usually the easier fix.
Standard steps
- Inspect the vialConfirm the label and that the powder cake is intact. Do not use a cracked or compromised vial.
- Let it reach room temperatureSitting out for a few minutes reduces condensation inside the vial when the seal is broken.
- Disinfect both stoppersWipe the compound vial and the bacteriostatic water vial with a fresh alcohol swab and let them air-dry.
- Draw the bacteriostatic waterUse a sterile syringe to draw the volume you have chosen from the reconstitution table.
- Add the water down the vial wallInject slowly so it runs down the inside wall rather than spraying directly onto the powder. This limits foaming.
- Dissolve gentlySwirl or roll the vial between your hands until the cake dissolves. Never shake — agitation damages peptide bonds. The solution should end up clear.
- Label and refrigerateWrite the reconstitution date and concentration on the vial. Store at 2–8°C. Do not freeze.
This page is an educational research reference and is not medical advice. CJC-1295 with DAC is not approved for human use in any jurisdiction. Dose figures reflect the published record and what the community has converged on — starting points to weigh, not instructions. Consult a qualified healthcare provider before starting any protocol.